Ssh into switch then telnet local – commands still work working on unifi pro 48 Currently with normal switch cli commands.Īpplication Start or stop an application.Īrp Purge a dynamic or gateway ARP entry.īoot Marks the given image as active for subsequentĬablestatus Isolate the problem in the cable attached to anĬlear Reset configuration to factory defaults.ĭelete Deletes the given image or the language pack file.ĭisconnect Close remote console session(s).ĭot1x Configure dot1x privileged exec parameters.Įnable Set the password for the enable privilege level.įiledescr Sets text description for a given image. Yes telnet is still available from within a local SSH session.
#How to use telnet to reboot router how to#
Here is an example of how to change the description for interface 0/1 To make changes to the switch configuration use the configure command to enter config mode. (UBNT) # copy system:running-config Backup unifi switch config over TFTP If you want to backup the configuration file you can use one of the following commands. Once you have reached the (UBNT) # prompt you are effectively configuring an EdgeSwitch, here is the EdgeSwitch CLI command reference. !System Up Time "61 days 16 hrs 24 mins 2 secs" The changes may break controller settings and only be effective until reboot. Type “ show run” to output the running configuration of the switchīusyBox v1.19.4 ( 21:42:26 PDT) built-in shell (ash)Įnter 'help' for a list of built-in commands.The credentials can be found in your UniFi controller’s settings. Here is how to connect to the UniFi switch CLI When you SSH to the switch you only get a linux shell prompt rather than a command line interface. As you know, UniFi Switches are controlled and configured through the UniFi Controller.
In this article, I will show you how to access a UniFi switch’s CLI interface and configuration.
0 kommentar(er)
